Sailfish 30-06 CC Visalia CA

The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

A Sailing Obsession
(559) 901-8075
940 County Center Drive
Visalia, CA
 
Han`s Boat Works Inc
(559)739-2628, (559)739-2627
301 West Noble Avenue
Visalia, CA
 
Bob`s Service Center
(559) 627-6446
105 North Valley Oaks Drive Suite A
Visalia, CA
 
Etco Marine
(559) 734-7471
15366 Avenue 296
Visalia, CA
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Central Valley Mastercraft
(800) 993-7278
Call, eMail or visit the website
Tulare, CA
 
Blue Water Marine
(559) 738-1631
Visalia, CA
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Sierra Model Yacht Club
(559) 627-0399
1749 E Mary Ave
Visalia, CA
 
Etco Marine, Inc.
(559) 734-7471
15366 E. Mineral King Avenue
Visalia, CA
 
Honda Motorcycles Authorized Sales & Service
(559) 733-8585
2036 East Mineral King Avenue
Visalia, CA
 
Pacific Yamaha
(310) 891-6990
1358 Pacific Coast Hwy
Hanford, CA
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Sailfish 30-06 CC

Provided by:

Click here for more content from JDPower.com

Model Introduction
The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

Construction
The skin coat of chop in DCPD resin goes down over the gelcoat, followed by a solid hull laminate of knit fiberglass in the sides and woven roving in the bottom. The hull is supported by a fiberglass, foam-cored Compsys stringer system, and the bulkheads are also foam-cored. The whole network is encapsulated in fiberglass and bonded to the hull. The transom is built of high-density poured foam-cored transom encapsulated in fiberglass. The hull-to-deck joint is bonded with urethane adhesive and stainless self-tapping screws every foot. The rubrail and the stainless insert follows with two more rows of screws fastening the joint. The one-piece cockpit/liner is bonded to the stringers with urethane putty, becoming an integral part of the boat's structure. The cabin liner is also bonded to the hull and to the cockpit liner where they meet at the aft cabin bulkhead. The Sailfish comes with a 10-year structural warranty that covers the hull against defects.

Hull Design
The Sailfish 30-06 CC has a deep-vee hull form with a sharp, deep entry and 24° of transom deadrise. Reverse running strakes (they turn up rather than down from garboard to chine), similar to the old Sea Craft hulls, run the length of the bottom. Its high freeboard increases seaworthiness, helping to prevent boarding seas, while providing high gunwale coamings inside the cockpit and a relatively high cockpit deck level above the waterline. ...

Click here to read the rest of the article at JDPower.com