Sailfish 30-06 CC Merced CA

The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

McClure Point Marina
(209) 378-2441
3100 Barrett Cove Rd
Snelling, CA
Services
McClure Point Marina

Data Provided by:
International Inboard Marine
(209) 384-2566
2556 W 16Th St
Merced, CA
Services
Parts, Service, Aftermarket Accessories, Trailers, Supplies, Storage

Fine Line Industries
(209) 384-0255
455 Grogan Avenue
Merced, CA
 
Merced Power Sports
(209)722-8055Q
265 West 15th Street
Merced, CA
 
M B Sports
(209) 357-4153
280 Airpark Road
Atwater, CA
 
Lake Mc Clure-Lake Mc Swain
(209) 378-2521
9090 Lake Mcclure Rd
Snelling, CA
Services
Lake Mc Clure-Lake Mc Swain

Data Provided by:
Stor-All Mr
(209) 722-8631
2785 North Santa Fe Avenue
Merced, CA
 
Ferriera Racing
(209) 384-9284
819 West 16th Street
Merced, CA
 
Malibu Boats West Inc
(209) 383-7469
1 Malibu Court
Merced, CA
 
Vallely Boat Rentals
(949) 673-1440
508 S Bayfront
Newport Beach, CA
Services
Vallely Boat Rentals

Data Provided by:
Data Provided by:

Sailfish 30-06 CC

Provided by:

Click here for more content from JDPower.com

Model Introduction
The Sailfish 30-06 Center Console is the largest model in the builder's lineup. It has a clear mission"offshore fishing. Not that it isn't also for other activities as well, such as diving and day cruising, but this boat is designed to head well offshore for fishing, and do so in comfort.

Construction
The skin coat of chop in DCPD resin goes down over the gelcoat, followed by a solid hull laminate of knit fiberglass in the sides and woven roving in the bottom. The hull is supported by a fiberglass, foam-cored Compsys stringer system, and the bulkheads are also foam-cored. The whole network is encapsulated in fiberglass and bonded to the hull. The transom is built of high-density poured foam-cored transom encapsulated in fiberglass. The hull-to-deck joint is bonded with urethane adhesive and stainless self-tapping screws every foot. The rubrail and the stainless insert follows with two more rows of screws fastening the joint. The one-piece cockpit/liner is bonded to the stringers with urethane putty, becoming an integral part of the boat's structure. The cabin liner is also bonded to the hull and to the cockpit liner where they meet at the aft cabin bulkhead. The Sailfish comes with a 10-year structural warranty that covers the hull against defects.

Hull Design
The Sailfish 30-06 CC has a deep-vee hull form with a sharp, deep entry and 24° of transom deadrise. Reverse running strakes (they turn up rather than down from garboard to chine), similar to the old Sea Craft hulls, run the length of the bottom. Its high freeboard increases seaworthiness, helping to prevent boarding seas, while providing high gunwale coamings inside the cockpit and a relatively high cockpit deck level above the waterline. ...

Click here to read the rest of the article at JDPower.com